sP20-in | The fireplace EDITION 07 / 2026 NETWORK CONNECTION There are two options available for installing the communication module: a Wi-Fi connection and a wired connection via an Ethernet cable to the router (possibly via PLC modules that allow data to be transmitted via the mains electricity network). You can do this by using a PC and downloading an application such as Netspot Free Edition (Windows or Mac), Vistumbler (Windows) or Wi-FiInfoView (Windows). These applications will allow you to quickly assess the characteristics of your home Wi-Fi network. Connecting the sP20 S to your home network 2.4 GHz 2.4 GHz >40% 801.11b/ g/n ‘ \ espace A Wi-Fi network exists on the 2.4 GHz bandwidth There is no 2.4 GHz Wi-Fi network, or the Wi-Fi configuration does not meet the required constraints. It is not possible to connect a cable directly between the stove and the router. Install a PLC module on your stove's power socket and a second one next to your router*, then connect the stove to the PLC using a UTP cable**. The 2.4 GHz Wi-Fi network can be detected with a signal strength of more than 40% at the stove's location The Wi-Fi network supports the 802.11b/g/n standard The Wi-Fi network encryption protocol is WPA2 PSK (AES or TKIP) The SSID and password of the 2.4 GHz Wi-Fi network do not contain single quotes ('), backslashes (), or spaces The stove can be connected to your home Wi-Fi network* *The home network router must also meet the following requirements: - IP address assignment on the server must be managed automatically by a DHCP. - Ports 1883 and 443 must be open to the outside. **The network cables used must be of category 5e or higher An Ethernet cable (UTP) ** can be connected between the stove and the router. Note: A wired connection is always preferable as it is much more stable and does not require any initial configuration. * The home network router must also meet the following requirements: • IP address assignment on the server must be managed automatically by a DHCP • Ports 1883 and 443 must be open to the outside **The network cables used must be of category 5e or higher
RkJQdWJsaXNoZXIy OTcxMTM1